FLEX THERMOMETER MT1931 COLPHARMA

FLEX THERMOMETER MT1931 COLPHARMA

COLPHARMA

Flex Thermometer MT1931

CE Class IIa medical device.
Thermometer that takes measurements in 60 seconds, without mercury.
With flexible probe, memory of last measurement.
Waterproof with acoustic signal.

Important precautionary measures
- The thermometer is used exclusively for measuring body temperature.
- The thermometer finishes measuring the body temperature correctly only when it is acoustically signalled by the < >.
- The thermometer contains small parts (batteries, etc.) that can be swallowed by children. Never leave the thermometer within the reach of children.
- Protect the thermometer from impacts.
- Avoid tilting the probe more than 45°.
- Avoid ambient temperatures above 60°C: do not boil the thermometer.
- Use only disinfectants listed in the < section > to clean the thermometer. The thermometer must be intact when immersed in the disinfectant liquid.

How to use
Turning on the thermometer:
To turn on the thermometer, press the button next to the display; a short beep indicates that the thermometer is on. A display test is automatically performed.
All icons must appear on the display.
When the ambient temperature is lower than 32°C, a < will appear on the display. > (Low – temperature too low to be detected) and a flashing <<°C>> at the top right. The thermometer is now ready for use.
Instructions for use:
Choose your preferred measurement method.
During measurement, the temperature is displayed continuously and the <<°C>> symbol flashes.
When the temperature increase is less than 0.1 °C every 16 seconds the acoustic signal (beep-beep-beep-beep 10 times) will warn that the temperature measurement is finished, the <<°C>> symbol will stop flashing and the thermometer will be ready to read the body temperature.
To extend battery life, turn off the thermometer after use by briefly pressing the on/off button.
The thermometer will automatically turn off after about 10 minutes.
Recording of measured values:
If you hold down the button for more than three seconds when you turn on the thermometer, the temperature recorded during the last measurement will automatically appear on the display and a small < > will indicate that the reading is of a data in memory.
After 3 seconds this value will disappear and the thermometer will return to normal measurement mode.
The recorded value is deleted.

Code MT1931